This searches the Website not the forum

Philips CP110 Stock Faults

You are here:
< Back

CP110 FLASHING PIC,R3415(470K),R3412(180R) ON CRT BASE PCB
CP110 RAGGED VERTICALS C2633 100UF
CP110 SURGE/OFF DEGAUSSING POSISTOR
CP110 (EARLY VERSION) POOR/SLOW CONTRAST,C2670 AND C2621
CP110 24″ SND ON VISION C2661 , RESOLDER TX
CP110 BLACKS OUT INT,R3415(470K) ON CRT BASE PCB.
CP110 BLANK RASTER “E” MICRO PRO.
CP110 BLOWS IN STBY REAPIR THEN MOD C2661 TO 2200UF REMOVE C2657. R3658 120R R3659 100R
CP110 BOTTOM CRAMP R3572 1R5
CP110 BOTTOM HALF MISSING, R3572 (1R5 )
CP110 BU508A BURNUP C2611 +R3599(47R)+BF819 EW ON CRT BASE.
CP110 BUT11AF BRIDGE RECT TEA1039 R3658 120R R3659 100R C2657 1.5NF C2661 TO 2200UF, CNX62
CP110 BUT11AF FIT C2661(2200UF) IN PSU.
CP110 BUT11AF TEA1039 C2661 TO 2,200UF, REMOVE C2657 CNX62 ADD 39R ACROSS L5656
CP110 BUT11AF+TEA1039+D66576660(4*1N5061)+
CP110 BUT18AF CHOPTR D6612 D6614 D6646, D6649, TR7655, TR7656 TR7654
CP110 CHANNEL DISPLAY KEEPS GOING TO ‘E’: MICROCONTROLLER CHIP 7840 FAULTY.
CP110 CHOPTR(BUT11AF) AGAIN,BRIDGE(1N5061),R3658(120R),R3659(100R)
CP110 CHOPTR(BUT11AF) AGAIN,TEA1039+C2661(2200UF),CNX62,ADD 39R ACROSS L5656
CP110 COLD LINE TEARING C2633(100UF25V) LINE DRIVER DECOUPLER.
CP110 COLD NO PIC,C2621,C2370
CP110 COLD NO PIC/SND REPLACE CNX62A OPTOCOUPLER TR7670 IN POWER SUPPLY.
CP110 DARK PIC C2621(22UF260V)
CP110 DEAD POWER KIT + 2.4V CELL.
CP110 DEAD ,C2656(150UF385V)
CP110 DEAD 1N4148 DIODE D6733, BESIDE THE MICROCONTROLLER CHIP.
CP110 DEAD 300V OK, C2656
CP110 DEAD 300V OK,C2656 150UF, 385V.
CP110 DEAD BUT11AF TEA1039 R3659 100R R3658 120R
CP110 DEAD BYD33D D6672
CP110 DEAD CHOPPER +TEA1039+OPTO CAUSE=BD438 TR7727
CP110 DEAD CHOPTR ETC
CP110 DEAD COIL 5608
CP110 DEAD D6672(BYD33D)
CP110 DEAD F1 7739 IN PSU
CP110 DEAD F1 1A6 WICKMAN FUSE F1653 CNX62A OPTOCOUPLER
CP110 DEAD F1 7739 BC548.
CP110 DEAD F1 FUSE F1653 CNX62.
CP110 DEAD F1, NO SUPPLY AT PIN 12 OF THE SYNC/IF MODULE.
CP110 DEAD F1, OPTOCOUPLER IC7670
CP110 DEAD FUSE,A SMALL SUB-PANEL TR7691 BC368 AND D6691 18V ZENER C2656 150UF, 385 V
CP110 DEAD LO 300V, C2656 150UF,
CP110 DEAD LOPTR THEN LOOKS LIKE LOPTX TDA2579+D6067 3V9 ZENNER.
CP110 DEAD LOPTR,3.9V ZENER DIODE D6067,
CP110 DEAD O/VOLT TRIP.WICKMAN 1653+CNX62
CP110 DEAD. HT OK, NO TUBE HEATERS, NO VOLTS ON LINE DRIVER. R3628 6.8 OHMS OPEN CIRCUIT.
CP110 DISPLAY F1 TRANSISTOR 7739 (BC548) SHORT-CIRCUIT.
CP110 DYNATRON CTV114
CP110 EARLY CHASSIS ONLY DULL PIC LIKE TUBE C2670,C2621
CP110 EW R3599 47R
CP110 EW , BF819 TR7600 BC558, R3588 15K R3587 1K8 R3599 47R C2589 33UF,
CP110 EW R3599 47R T7600 BC558 T7601 BF819
CP110 EW RASTER CRT BASE .
CP110 EW RASTER,NO ADJUST,R3599(47R) ON CRT BASE PCB.
CP110 F1 7739 BC548
CP110 F1 DISPLAY ,FIELD COLLAPSE IC7675 PINS.
CP110 F1 FIELD COLLAPSE. 12V REGULATOR IC7675.
CP110 FIELD TDA3566
CP110 FIT 39R ACROSS L5656+REMOVE,C2657+C2661TO2200UF+DEGAUSE POSISTOR+R3658+R3659+C2656.
CP110 FRAME COLLAPSE, REPLACE 3570 8.2K OHM WIRE WOUND RESISTOR OPEN CIRCUIT.
CP110 FUSE BRIDGE RECT, RESERVOIR CAPACITOR 150UF 385V
CP110 HAVE CCT DIA 140V.
CP110 HT (140VN)LOW AT 60-70 VOLTS CHECK C2661 2200UF O/C.
CP110 IF CAN PATTERNING/NO TEXT, COIL L5082
CP110 INT DEAD BC337 LINE DRIVER TRANSISTOR TR7630
CP110 INT FIELD COLLAPSE 12V REGULATOR 7675 BEHIND TUNER.
CP110 INT PIC/POWER/FLASHING), DEGAUSS POS,CHOPTX.
CP110 INT POOR STARTUP/TRIPPING C2690(100UF50V) ON OVERVOLTS SUB PANEL.
CP110 INT STOP/START, DRY-JOINT AT PIN 2 OF THE CHOPPER TRANSFORMER
CP110 INT TRIPS TO STBY CHOPPER TX PINS.
CP110 JUNE 1993 PAGE 574 T/V MAGAZINE
CP110 LATER (TR7672 IN PSU) COLD POOR CONTRAST TR7672. C2670 C2621
CP110 LINE OUTPUT TRANSFORMER PTNO4822 140 10325.
CP110 LO HT C2690(100UF50V).
CP110 LOW POWER O/P PULSING, C2690(100UF50V) ON SMALL SUB PANEL.
CP110 LOW POWER O/P PULSING, HT TO HI TRIPPING.
CP110 NICAM DISTORTION/OK IN MONO, REPLACE TDA1543
CP110 NO DISPLAY, LO 140V , 6V REGULATOR TRANSISTOR 7738 BC558
CP110 NO DISPLAY. 140V LINE LOW 60-80V: THE 6V REGULATOR TRANSISTOR 7738 (BC558)
CP110 NO EW CORRECTION R3599(47R) ON CRT BASE.
CP110 NO PIC EHT OK, R3570 8K2
CP110 NO PIC EHT OK, R3570 82K
CP110 NO PIC SND PULSING / LO HT, 100UF HT +C2633(100UF) LINE DRV FEED.
CP110 NO PIC/SND “F1” MICROPRO OR 7739(BC548.
CP110 NO SND TDA8190+R3102+R3672.
CP110 NO SOUND R3672(1R) NEAR CHOPPER TX CAUSE CHOPTX EARTH PINS.
CP110 NO SOUND R3672(1R) NEAR CHOPPER TX CAUSE CNX62 ?.
CP110 NO START UP, LOW OR NO 14V TO PIN 9 OF IC7669 TEA1039, CHECK C2656 150UF385V
CP110 NO/POOR REMOTE CONTROL C2967 (100UF, 10V) INSIDE THE REMOTE CONTROL RECEIVER CAN.
CP110 PIC BLANKED EVERY SECOND,R3415 470K ON TUBE BASE PCB.
CP110 PIC BLANKS ON/OFF TDA3562A TR7413 R3415 470K CRT BASE PCB
CP110 POOR START C2690 100UF, 50V ON THE MAINS OVER VOLTAGE SUBPANEL.
CP110 PSU LO/PULSING C2690 100UF, 50V THAT IS MOUNTED ON A SMALL SUB PANEL
CP110 PSU1 BUT11AF TEA1039,BRIDGED ADD 39R ACROSS L5656.CUT OUT C2657
CP110 PSU2 CHANGE C2661 TO 2,200UF,DEGAUS POSISTOR R3658 120R R3659 100R, C2656 150UF, 385V
CP110 RAGGED VERTICALS C2633 (100UF)
CP110 RAGGED VERTICALS C2633 100UF, 25V,
CP110 RAGGED VERTICALS C2661(100UF) LINE DRIVER.
CP110 RAGGED VERTICALS, C2633 100UF
CP110 RAMDOM CHANNEL CHANGE, KEYBOARD FOIL, WHERE IT SLOTS INTO THE SOCKET ON PCB
CP110 REPEATED FAILURE OF THE BUT11AF(7665)CHECK RESISTOR 3658 120R, AND 3659 100R
CP110 RHS TEXT, ROM CHIP UPD4364.
CP110 SEE PHILIPS2.TV.HTML
CP110 SLOW PIC C2670/2621 (22UF).
CP110 SLOW POOR PIC 22UF, 250V C2670.
CP110 SLOW START C2670 C2621. 100UF, 50V CAP MOUNTED ON A SMALL PCB NR CHOPPERTX
CP110 SLOW START C2670/2621(22UF)+C2656(100UF50V).
CP110 SLOW START R3617 220K SM
CP110 SLOW/DARK PIC LO HT C2621 22UF, 250V,
CP110 SMALL DARK PIC 88, DIODE D6901 PROVED TO BE THE CULPRIT.
CP110 SND OK NO PIC CNX62A OPTOCOUPLER. TR7670,
CP110 SND OK, BLUE RASTER TR7405 BF432
CP110 STBY 100UF ON PULSING SMALL SUB-PANEL
CP110 T/TEXT FAULT RHS LETTERS UPD4364 .
CP110 TEA1039+CHOPPER.
CP110 WILL NOT START UP, D6672 BYD33D IN 32V LINE
CP110,EW RASTER CRTPCB,TR7600(BF819)+TR7601(BC558)

0 0 votes
Article Rating
Subscribe
Notify of
guest

This site uses Akismet to reduce spam. Learn how your comment data is processed.

0 Comments
Inline Feedbacks
View all comments
Table of Contents
0
Would love your thoughts, please comment.x
()
x