Set up EHT :Thorn 3000/3500

You are here:
< Back

There are two recommended and official methods.

The first is by setting the collector peak voltage at VT504, this requires the use of the Thorn CPV diode kit. The device basically takes the collector voltage, rectifies and smooths it and then is used in conjunction with an AVO 8 (shown below). Not only can you set the 3K series chassis using this device but also the other chassis in the BRC/Thorn family, details of which are in the following table.

SeriesCollectorAVO8 RangeMeter Reading

eht2 eht3

Method 2

The second method involves measuring  the current in the focus resistor chain which is connected in shunt with the EHT circuit. To do this you have to transfer the focus panel to the long earth tag on the left-hand side of the spark protection on the CRT base PCB. With an AVO 8 set on 250uA range between chassis and the focus panel test point, with the contrast at minimum and the three gun switches off, the SET EHT control is adjusted for a reading of 12uA.

Other ways

Some engineers of old admitted they just adjusted the control to obtain 58-65 on the Chopper rail fuse F603. Although under certain conditions and depending on the Line Timebase module, this was known to cause excessive EHT. Although not officially approved many service engineers were advised if using this method to set it for 61V in the interests of preserving the tripler.

Table of Contents

Leave a comment

I have read the privacy policy and accept
Read our privacy policy

This form collects your name, email and content so that we can keep track of the comments placed on the website. For more info check our privacy policy where you will get more info on where, how and why we store your data.

This site uses Akismet to reduce spam. Learn how your comment data is processed.